Schlage Connect: Manual Programming Instructions

The Schlage Connect Series BE469ZP and the discontinued Schlage Connect Series models BE469, BE469NX, BE469IR, BE469WK, BE468, and BE468GBAK are all compatible with third-party hubs. They can connect via their corresponding apps and be controlled through those apps. Additionally, each of these locks can be programmed manually. Please see the programming instructions below.

In This Article:

Add a Code

Delete a Code

Change the Programming Code

How to Enable/Disable the Keypad Beeper:

How to Enable/Disable One-Touch Locking:

How to Enable/Disable Auto-Lock:

Temporarily Disable Auto-Lock:

Restore Auto-Lock

To Add a Code:

1. Press the Schlage Icon.
2. Enter the 6-digit Programming Code. 
   Programming indicator light blinks.
3. Press 1. 
   The keypad will display a Green checkmark.
4. Enter a new user code (4-8 digits).
   The keypad will display a Green checkmark.
5. Enter the same new user code a second time.
   If successful you'll see two Green Checkmarks and hear two beeps.
6. To add more codes, repeat steps 4-5.
7. To exit programming mode, press the Schlage Icon. 

To Delete a Code:

1. Press the Schlage Icon.
2. Enter the 6-digit Programming Code. 
   Programming indicator light blinks.
3. Press 2. 
   The keypad will display a Green checkmark.
4. Enter the user code (4-8 digits) you wish to delete.
   The keypad will display a Green checkmark.
5. Enter same user code a second time.
   If successful you'll see two Green Checkmarks and hear two beeps.
6. To add delete more codes, repeat steps 4-5.
7. To exit programming mode, press the Schlage Icon. 

To Change the Programming Code:

1. Press the Schlage Icon.
2. Enter Programming Code. 
   Programming indicator light blinks.
3. Press 3.
   The keypad will display a Green checkmark.
4. Enter new Programming Code.
   The keypad will display a Green checkmark.
5. Enter same new Programming Code. 
   Success is indicated by 2 blinks + 2 beeps.

How to Enable/Disable the Keypad Beeper:

1. Press the Schlage icon.
2. Enter Programming Code. 
   Programming indicator light blinks.
3. Press 5. 
   The keypad will display a Green checkmark.
4. Enable: 1 blink + 1 beep.
5. Disable: 2 blinks + 2 beeps.

How to Enable/Disable One-Touch Locking:

• When enabled: Press the Outside Schlage Button to lock the deadbolt. (Default setting).
• When disabled: Press the Outside Schlage Button and then enter an access code to lock the deadbolt.

1. Press the Schlage icon.
2. Enter Programming Code.
   Programming indicator light blinks.
3. Press 7.
   Success! 2 blinks + 2 beeps.

How to Enable/Disable Auto-Lock:

• When enabled, the lock will automatically relock 30 seconds after unlocking. (Disabled by default).

 

1. Press the Schlage icon.
2. Enter Programming Code. 
   Programming indicator light blinks.
3. Press 9. 
   Success! 2 blinks + 2 beeps.

Temporarily Disable Auto-Lock:

• Auto-Lock must already be enabled.

1. Press the  Schlage Icon.
2. Enter User Code.
3. Within 5 seconds, manually lock and unlock the deadbolt using the thumb-turn. 
   Green checkmark, 1 blink + 1 beep.

Restore Auto-Lock

Just relock the deadbolt using the thumb-turn. 
Green checkmark, 2 blinks + 2 beeps